Key's Racing Original Shift Knob Suede KeysRacing-OS-17

Key's Racing

Brand
Key's Racing
Product Number
KeysRacing-OS-17
Compatible Car
Universal
Product Description
Key___s Racing offers a gear shift knob as well as steering wheels. In developing this product, we incorporated into it the texture and level of perfection of our steering wheels. To enable drivers to move the lever in a fraction of a second, maximum consideration was given to comfort and the feel of gripping the knob. The knob shares the same design themes as the steering wheel. I think that using our shift knob along with one of our steering wheels will give you a personalized cockpit. Naturally, the KEY___S logo is embroidered in quality thread on the product.
As with our steering wheels, it is offered with a Suede or a Smooth Leather wrap. Nonslip Suede is recommended for hard driving, while Smooth Leather is ideal for city driving and the creation of a stylish cockpit.
A three-dimensional rendition of our KEY___S RACING logo is engraved on a ring at the bottom of the knob.
The Key___s Racing Shift Knob can be installed on most of the cars of both Japanese and overseas makers by using the included attachments. For compatible vehicles and how to install the knob, refer to the explanations below.
Features of compatible vehicles
__  Using a gate-type automatic transmission (to be replaced with a chrome cap)
Original factory-fitted knob is removable and original factory shaft measures 8mm or 10mm in diameter.
Any screw pitch is OK.
Toyota, Mazda, Honda, Daihatsu, Mercedes, etc.
__  Using a manual transmission (to be replaced with a black cap) Original factory-fitted knob is removable and original factory shaft measures 10mm, 12mm, or 14mm in diameter.
Any screw pitch is OK.
Package includes
1. 1 pcs x Chrome bottom cover
2. 1 pcs x Black bottom cover
3. 3 pcs x Resin inner sleeve (8___10, 12, 14mm in diameter)
4. 9 pcs x Fixing screw (M3 / 4, 6, 8mm in length)
5. 1 pcs x Hex key for fixing screws
How to Install
1. Remove original factory gear shift knob.
2. Drop bottom cover (either chrome or black) onto original factory shaft.
3. Fix resin inner sleeve compatible with screw diameter of factory shaft.
(a) Resin inner sleeve edge bearing number (i.e., 10, 12, or 14) should be at top.
(b) Resin inner sleeve is fixed not by tightening screws but by threading sleeve.
(c) Resin inner sleeve is used only to stabilize upper part of shaft, after product has been fixed with three screws as described below.
4. Put knob over top of original shaft.
5. Fix knob with screws that fit diameter of holes in factory shaft.
(a) Do not fix screws over resin inner sleeve.
(b) Fix three screws directly to factory shaft.
6. Fix bottom cover to knob.
___The product is 85mm long inside. If the original factory shaft is longer than 120mm, the product may be fixed in a high position. On the other hand, if the original shaft is short, for instance around 100mm in length, the product needs to be fixed at a relatively high position on the original shaft. In this case, the bottom part of the resin inner sleeve needs to be trimmed to prevent it from interfering with the screws. (The resin inner sleeve can be cut easily with a cutter. Be careful when handling the cutter.) Because the fixing positon of the product is arbitrary, you can decide where to fix it.
Wrap: Suede
Notes
Images are for illustration purpose only. Actual product may vary.


Next Previous

Related Items