RECARO BASE FRAME SEAT RAIL RIGHT SEAT FOR BMW MINI ROADSTER R59 2014.063.2

RECARO

BASE FRAME SEAT RAIL RIGHT SEAT

2014.063.2

BMW MINI ROADSTER R59

YEAR MODEL: 2012-01-2015-02
Note: It cannot be installed on seats other than those listed in the matching information below. sports frame. R59. Comes with side airbag canceller.RECARO can also be installed on the passenger seat only if the vehicle does not have a occupancy sensor on the passenger seat. *As of 2013, the measurement vehicle does not have a seating sensor, but this may change in the future, so it is necessary to confirm the presence in advance. For details, please contact a dealer familiar with this vehicle. Vehicles that do not have a seating sensor on the passenger seat do not require a separately sold part (naviseat selector). Due to rear space limitations, the TS-G has been removed from the mounting sheet. Regarding the coupe, it is unknown as there is no installation confirmation information. Special Note: The side airbag function built into the genuine seat will no longer be available. Airbag warning light needs to be turned off. The seating position is approximately 5mm lower than the lowest position of the genuine seat (when using ST-JJ). The seat offset is approximately 10mm closer to the door than the genuine seat position. (= Approximately 14mm from the handle center to the door side (Recaro moves closer to the door side).) The amount of rearward sliding is reduced by approximately 10mm compared to the genuine one.

The pillars of the Roadster protrude, so the shoulder area of the seat will interfere with it, limiting the range of movement depending on the front and rear positions, and the seat side will slightly interfere with the door side. Also, near the front position of the seat slide, the seat cushion and cup holder interfere. For manual LX and ERGOMED models, the reclining dial interferes with the door near the rear position, so it is necessary to remove the dial. SP-# requires SP-G offset adapter set . The shoulder part interferes with the B pillar by approximately 5 to 10 mm. Please exclude TS-G from installation as the rear side will interfere. For RS-G, the handle offset can be adjusted in 5mm increments from 5mm to a maximum of 15mm using the RS/TS-G offset adapter set . (When installing, please consult your dealer to avoid interference with the console side (shift, etc.)) The RMS can be adjusted to the optimal position (front/rear height, left/right offset 0/5/10 mm) using the separately sold RMS side adapter. Please put it on. Also, if there is interference with the interior, it can be alleviated by adjustment. Please adjust the RCS to the optimal position (front/rear height, left/right offset 0/5/10mm) using the separately sold RCS side adapter and install it.

Images are for illustration purpose only. Actual product may vary.