J'S RACING PILLOW TIE ROD END SET FOR HONDA S2000 AP1 2 F20C F22C PTE-S1

J'S RACING

PILLOW TIE ROD END SET

PTE-S1

HONDA S2000 AP1 2

F20C F22C

Material: 2017S + S45C + SCM435
By adopting the adjustable tie lot end shaft, it is possible to change the geometry with proper bump steer.

★ Improved straight-line stability
★ Improved tire contact feeling
★ Improved steering response
The mounting angle of the tie lot end is set to normal vehicle height to low vehicle etc. It can be adjusted according to any vehicle height, and the bump steering can be adjusted.
Bump steer is an element of suspension geometry and is the toe change that occurs when the tire moves up and down.
Especially in the case of S2000 where the vehicle height is lowered, the angle of the tie lot end becomes an inverted C shape, and when it exceeds a certain area, the toe change becomes extreme and it becomes a peaky geometry area.
Therefore, by installing this product, the mounting angle of the tie lot end can be used near the horizontal.
(In the case of S2000, the angle near the horizontal is the area where the toe change is relatively small.)
The important part of the S2000 suspension setting that J'S RACING thinks is the correction of this bump steer and the correction of the roll center.

In addition, the pillow balls used are those with excellent erosion resistance, so durability in normal use is sufficiently ensured.
(If it is damaged, it can be repaired with repair parts sold separately.)


It supports a wide range from street to circuit driving.
It is a must-have item for sports driving of S2000.
● Conforms to safety standards.

Engine: F20C F22C
(Set contents)
Pillow tie rod set right x 1
Pillow tie rod set left x 1

Please follow the specified torque and install correctly.
Alignment adjustment is required after mounting.
* Please check the tightening of bolts and nuts regularly after mounting.
Please do this every time, especially before driving on the circuit.

Images are for illustration purpose only. Actual product may vary.