RIZE JAPAN CARBON CANARD KIT FOR NISSAN SKYLINE GTR R34

RIZE JAPAN

CARBON CANARD KIT

RIZE-JAPAN-00022

NISSAN SKYLINE GTR R34

It is a carbon two-stage canard for exclusive use of R34 Skyline GTR genuine bumper. In order to increase the sense of unity, the main body stay part and side flange (outside) are integrally shaped with carbon. In the end, it became this shape in order to achieve both performance and design. By integrating the stay and the main body, bolts, screws, rivets, etc. do not appear on the surface, so it is beautiful and has strength that general-purpose products cannot produce. The surface has a carbon, clear gel coat, and clear paint finish. Normally, the 34 bumper is equipped with a lip spoiler, so I think it will be tighter than in the photo. The 34 bumper is also reasonably priced and more people are attacked by the circuit. It seems that there are many cases where the GT wing etc. are attached and the aerodynamic aspect is also taken care of. We have recently developed the R34 model, paying attention to the aerodynamic balance of the front and rear and the design. On the lower side of the important canard, it extends from the bumper side toward the front of the bumper as much as possible, and the mounting point is provided to the front end to prevent vertical synergies when downforce is applied and pursue performance as much as possible. Furthermore, in the case of 34, further strength can be expected because it is extended to the mounting location such as the front lamp and fixed with screws. The strength is 4 plies in total. The important part is 6 plies. The thickness and strength are changed depending on the location. The stay part and side flap part have a rib structure to gain as much strength as possible. Also, there is a dent on the rear of the genuine bumper (near the tire) that is quite annoying when installing the canard, but I adjusted the shape so that it fits well there. The dimensions are quite large in our canard series. Since it can be installed only using the attached dedicated screw, it can be installed with a single Phillips screwdriver. Of course, there are holes for screws in the stay part, and mounting screws are also included. Since the bumper is made of urethane, there is no need to make a pilot hole. It is economical because there is no need to purchase mounting stays separately. The photo shows a sample product temporarily attached to the development bumper with tape, so it is not firmly fixed, but it is a screw. It is firmly fixed with a stopper. Please bid after seeing the photograph and being convinced. Since it was developed with the 34GTR genuine hamper you see, we do not match it with other bumpers (GTS, NISMO, outside the company, etc.). note that. The set includes a total of 4 canards and mounting screws. This exhibition is a two-stage specification. R34 skyline GTR original bumper exclusive use carbon two step Canard.The design made the body stays part, side flange (outer side) carbon therefore shaped to increase sense of unity.It finally became this form to make performance and design compatible.By integrating the stay and the main body, bolts, screws, rivets etc do not appear on the surface, so it is beautiful and strength that can not be taken out with general-purpose goods. The surface is carborne, clear gel coat, clear paint finish. Usually I think that the lip spoiler is attached to 34 bumpers so it will be tighter than the photo34 was also more affordable and more people attacked at the circuit.

Images are for illustration purpose only. Actual product may vary.