RIZE JAPAN CARBON CANARD KIT FOR NISSAN FAIRLADYZ 350Z Z33

RIZE JAPAN

CARBON CANARD KIT

RIZE-JAPAN-00026

NISSAN FAIRLADYZ 350Z Z33

As for the design, the main body and stay part are integrally shaped with carbon. By integrating the stay and the main body, it is beautiful and has high strength without any screws or rivets appearing on the surface. In the case of 33Z, the rounded shape of the canard mounting location is the opposite of the usual one, and the side marker lens is an obstacle, making it difficult to mount a general-purpose canard. We have developed a special product, so we would appreciate it if you could consider it. The surface is finished with carbon and clear gel coat. The mounting part has a shape that matches the dent of the side marker, so it does not give a sense of discomfort. Even when viewed from the side, the stay part is cut as long as it does not hide the marker. The strength is high strength 4-ply. The decrease in strength around the cut part increases the thickness around it by one ply to ensure rigidity. The side flaps are not at right angles, but are naturally lifted upwards to finish the rounded Z33's beautiful design without breaking it. As for the overall design, we refer to the canard installed in the Z currently participating in the GT Championship. It is designed to catch the air flowing outward from the center of the bumper and let it flow upward. I thought that something that was too big and bad would not suit this car, so by making the downforce that has been reduced a little small to two stages, the effect of one large piece or more will be demonstrated. It is especially suitable for balancing when the rear wing is attached. Of course, the size is also within the full length and width. The photo shows a sample product temporarily attached to the development bumper with tape. Please bid after seeing the photograph and being convinced. This is for the Z33 early model bumper. The latter model cannot be installed because the shape of the side reflector is different. Since it can be installed only using the attached dedicated screw, it can be installed with a single Phillips screwdriver. Of course, there are holes for screws in the stay part, and the set contents are 4 pieces on the left, right, top and bottom and mounting screws. Since the genuine bumper is made of urethane, there is no need to make a pilot hole. Tori It is economical because there is no need to purchase a gluing stay separately. Design was the main body, and carbon together shaping the stay part. By integrating the stay and the body Beautifully without leaving the screws and rivets on the surface, and it's high strength. In the case of 33Z, and the fact that Earl shape of canard attachment point is usually the opposite, Canard such as general-purpose becomes a side marker lens is the way it was difficult mounting. This time, we would appreciate your consideration because we have developed a dedicated product. Surface Kabon, clear gel coat finish. Mounting portion has a shape to match the dents of the side marker, It does not give a sense of discomfort. When viewed from the side as well, so that the stay portion does not hide the markerYes to cut as long as possible. Strength high -strength 4-ply.

Images are for illustration purpose only. Actual product may vary.